Brother PR-1000 Manual De Instalación página 5

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
● When hooping a shoe in the clamp frame,
the heel of the shoe should extend out
from the notch in the frame. If the heel of
the shoe is inside the notch, the shoe may
hit the embroidery machine, preventing
embroidering.
1 Notch
● If the shoe is hooped with the sole and
clamp frame at an angle greater than 45°,
we recommend using clamp frame S, even
if the shoe is a size 27 cm (US9/UK8/
EUR42) or more.
● If the nuts are tightened too firmly when
removing the item from the frame after
embroidering, press the area between the
two screws with your fingers and use the
wrench included with the embroidery
machine to loosen the nuts.
Attaching the embroidery
frame
After hooping the item in the clamp frame, attach
the frame to the embroidery machine.
● When attaching or removing the clamp
frame, make sure that the start/stop button
of the embroidery machine is lit in red. If
the start/stop button is flashing in green,
the embroidery machine may start sewing.
If the embroidery machine accidentally
starts operating, injuries may result.
● Before attaching the clamp frame, install
embroidery frame holder D on the
embroidery machine.
a
Memo
Note
1 Loosen and remove the two thumb screws
on the embroidery machine, and then
remove the embroidery frame holder from
the carriage.
a
1 Thumb screws
• The removed thumb screws will be used to
install embroidery frame holder D.
Insert the pins on the frame-mounting plate
2
of the carriage into the holes on both sides of
the mounting plate of embroidery frame
holder D.
b
1 Pins on the frame-mounting plate of the
carriage
2 Holes in the mounting plate of embroidery
frame holder D
3 Install and tighten the two thumb screws
removed in step
3/5
a
1
.