— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
About the Clamp Frame
You can hoop your item easily with one-touch
operation, or easily rehoop the items without
removing the embroidery frame from the machine.
You can also embroider items such as small bags,
scarves or garment hems using this frame.
Verifying the package
contents
Check that the following parts are included. If any
item is missing or damaged, contact your
authorized sales representative.
● The maximum embroidery area of the
clamp frame is 100 mm × 100 mm (4
inches × 4 inches).
● When using the clamp frame, you cannot
embroider to the area more than 160 mm
in height.
1 Embroidering available height
■ Contents of clamp frame kit
1.
Embroidery frame holder D
1
Clamp frame
2
Installation Manual
3
* Install embroidery frame holder D in order to
attach the clamp frame.
Note
2.
Hooping the fabric
● When embroidering using the clamp
● When embroidering specially processed
1
Press the left and right lock release levers to
unlock the upper frame.
1 Lock release levers
2
Lay the fabric with stabilizer between the
upper and lower frames.
● The upper portion of the frame can be
3.
1/3
Note
frame, we recommend that the fabric have
a maximum thickness of 2 mm.
fabrics, such as those with a non-slip lining,
embroidering may not be possible even if
the fabric thickness is less than 2 mm.
Memo
flipped so that you can utilize either side
of the frame that best works with your
fabric type. Using the pile textile side for
rougher textured fabrics, while using the
spongy side for slippery fabrics.