Milnor MilTouch-EX 48040H7K Guía Del Operario página 21

Data Transfer with the MilTouch Programmer Software
1.1.1.3.
this section to transfer these types of data between a MilTouch machine and a personal computer
running the MilTouch Programmer software:
• machine configurations
• wash formulas.
How to Mount a USB Flash Drive to the Machine Controller
1.1.1.3.
1.
a USB flash drive.
1. At the MilTouch machine, touch the Data Exchange button on the Home display
access the Data Transfer display
2. While the Information box is visible, attach a blank USB flash drive in the USB port on the
left side of the machine control box.
3. Touch the button in the Information box to clear the box.
4. If a green "+" is visible on the External Media button, then touch the button to mount the
USB flash drive. If a red "-" is visible on the button, continue with this procedure.
5. Touch the External Storage button to save the machine configuration on the flash drive.
6. Touch the Transfer Configuration button.
How to Save Machine Configuration Files
1.1.1.3.
2.
1. Touch the Data Set Name button.
2. To change the name of the configuration file, touch the Rename Data button, replace the
original name, and touch the button in the Information box to confirm the change.
3. Touch the bottom green Transfer Direction button to copy the configuration to the flash
drive.
4. Touch the button to confirm the successful export.
5. Touch the External Media button to unmount the flash drive.
6. Store the flash drive in a safe place.
How to Transfer Machine Configuration Files to a MilTouch Machine
1.1.1.3.
3.
procedure requires a USB flash drive that contains one or more MilTouch configuration files. The
previous section describes how to save machine configuration files to a USB memory flash drive.
1. Access the Data Transfer display.
2. Mount the flash drive according to
3. Touch the External Storage button to see a list of the available configuration files.
4. Touch the desired configuration file in the stored data area
5. Touch the top green Transfer Direction button to copy the configuration to the machine
controller.
6. Confirm the successful import, unmount the flash drive, and remove the flash drive from the
machine controller.
How to Save and Transfer Wash Formulas
1.1.1.3.
4.
1. This procedure requires a USB flash drive.
2. Access the Data Transfer display.
3. Mount the flash drive according to
4. Touch the Transfer Wash Formulas button.
Chapter 1. How to Use the MilTouch-EX
(Figure 5).
—This procedure requires a USB flash drive.
Section 1.1.1.3.1.
Section 1.1.1.3.1.
17
™
Washer-Extractor Control
—Use the procedures in
—This procedure requires
(Figure
—This
(Figure 6).
PELLERIN MILNOR CORPORATION
1) to