Klippan WEGO Manual De Instrucciones página 20

The shoulder belt guide should be slightly above the top of the child's
shoulder. At the same time, the shoulder belt should pass centrally
between the child's neck and the outer edge of the shoulder.
Seat your child well back in the seating area. Pass the three-point belt
across the front of the child to the seat belt lock, and fasten it in the same
way as for an adult. (There must be an audible click). Now position the
belts. Pass the lap belt across both sides and the diagonal belt on the side
of the seat belt lock through the lap belt guide. Finally pass the diagonal
belt through
The lap belt should be in the lowest position. If the vehicle is equipped with
a seat belt height adjustment, adjust the height suitable. To remove the
child from the seat, you only need to open the lock and pass the strap back
across the child. To release the strap from the belt-guide , pull the straps
forward and out.
Finally, pass the diagonal belt through the provided shoulder belt guide.
Make sure the belt passes inside the security hook.
The cover can be removed for washing. To do so, move the head section
to its highest position. To remove, pull the cover away from its anchoring
points. Begin by removing the head section followed by the seat section
and the shoulder shields.
To replace, start with the cover for the section. First pull the cover over the
cover panel on the backrest. Then pass it beneath the lap belt guides and
insert the fixings into the channel running along the edge of the seat.
Finally, attach the cover for the head section and should shields.
12
13
14
15-16
20