Optional Additional Settings; Adding/Deleting Rts Control Points; Creating Multiple Or Group Controls - SOMFY Lighting Modulis Ramp RTS Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43
Installation guide
6.2.2 Timer
-
Set the timer (Chronis) to US Mode to control the lighting from an
RTS timer.
1)
To switch the light on:
-
Press the Up button:
2)
To switch the light off:
-
Press the Down button:
3)
To switch the light on directly to the "my" preset favourite light
intensity setting
-
Press the my button.
4)
To increase the light intensity
-
Press and hold the Up button:
-
The light intensity increases as long as the button is pressed
-
Release the Up button when the required light intensity is reached.
5)
To decrease the light intensity
-
Press and hold the Down button:
-
The light intensity decreases as long as the button is pressed
-
Release the Down button when the required light intensity is
reached.
Caution: Once the "night-light" level has been reached, keep the Down
button pressed to switch the light off.

7. Optional additional settings

7.1 Adding/Deleting RTS control points

Caution! A maximum of 12 control points may be programmed into a Lighting Modulis RTS Ramp.
-
Press the PROG button on the programmed control point (a) until the ramp comes on then goes
out: the Lighting Modulis RTS Ramp will be in programming mode for 2 minutes.
-
Briefl y press the PROG button on the RTS control point (b) to be added or deleted: the ramp
comes on then goes out; the RTS control point has been added/deleted.

7.2 Creating multiple or group controls

7.2.1 Multiple control
Multiple control: a Lighting Modulis RTS Ramp is controlled by several
RTS control points.
Caution! A maximum of 12 control points may be programmed into a
Lighting Modulis RTS Ramp.
1) Press the PROG button on the programmed control point (A) until
the ramp comes on then goes out: the Lighting Modulis RTS Ramp
will be in programming mode for 2 minutes.
2) Briefl y press the PROG button on the RTS control point (B) to be
added: the ramp comes on then goes out; the RTS control point has
been added.
-
Repeat these two steps to add each RTS control point.
Copyright © 2009 Somfy SAS. All rights reserved.
5061612X00_LMR_RTS_livre.indb 37
Lighting Modulis RTS Ramp
1
ON
2
OFF
3
my
+
4
100%
-
0%
+
5
100%
-
0%
+
1
2
A
B
PROG.
PROG.
2 min.
+
1
2
A
B
PROG.
PROG.
2 min.
37
30/04/09 18:44:54

Publicidad

Tabla de contenido
loading

Tabla de contenido