Useful Tips - PNI Escort HP 8000L Manual De Usuario

EN
Typically, the antenna should be positioned on the highest side of the vehicle without being obstructed by
obstacles and as far from any electrical source or electromagnetic noise. The coaxial cable of the antenna
should not be interrupted or pressed. Connect the plug at the end of the coaxial antenna cable to the antenna
jack on the rear panel of the radio.
Check the radio:
Once installed and powered from the vehicle's electrical system, do the following to verify its operation:
• Check that the radio is powered correctly
• Check the antenna connection to the radio
• Connect the microphone to the jack on the front panel of the radio
• Turn on the radio by rotating the volume knob clockwise and adjust the volume to the desired level
• Select the desired channel with the UP / DOWN keys on the front panel or on the microphone.
• Press the SQ button in the limit area where the background noise disappears.
Note: If the ASQ mode is enabled (by pressing the ASQ on the microphone) the SQ button can not be activated
• Press the PTT button on the microphone to emit, and release it to receive
• Check the signal level received via the signal bars on the front panel
• Turn the ASQ function on the microphone and adjust its level from the ASQ button on the front panel of
the station

USEFUL TIPS:

Do not reverse the polarity when powering the radio.
Do not replace the fuse with a higher value. The fone from the factory has 2A.
Do not emit without an antenna or a broken or not tuned antenna to avoid burning the CB final output transistors.
Adjust the SQ and ASQ until the background noise disappears. By turning the SQ knob clockwise too much,
you will receive only the strong signals (those emitted nearby).
CHANGING THE STANDARD:
To change the standard in which you are using the CB radio, do the following:
• While holding down the Down and PTT buttons on the microphone, turn on the station
• Use the up and down keys on the station to select the desired setting
• Turn off and then restart the station
To check the current norm do the same procedure.
Available standards:
CE Romania
9 Germany
U UK
A Russia
b Russia
C Russia
d Italy)
E Spain
F France
P Poland
n Netherlands
26.9650-27.405
26.9650-26.955
27.60125-27.99125
25.6150-26.055
26.0650-26.505
26.5150-26.955
26.9650-27.405
27.4150-27.855
27.8650-28.305
26.9600-27.400
26.3300-26.770
6
FM 40 CH
AM 40CH / FM 80CH
FM 40CH
AM / FM 40CH
AM / FM 40CH
AM / FM 40CH
AM / FM 40CH
AM / FM 40CH
AM / FM 40CH
AM / FM 40CH
AM / FM 40CH