Steren CCTV-955 Manual De Instrucciones página 71

- Device ID: Allows you to set an identifi cation number to recognize the DVR remote
connections.
- Device Name: Lets you change the name of the CCTV-955.
- Loop record: Allows you to enable or disable the reuse of space in the disc.
Yes (enabled): This mode activates the function overwrite, i.e. when the hard disk is full, it
will begin to overwrite the oldest data.
No (off): The recording will stop when the hard disk is full.
- Lock Time: This option allows you to lock your device after being inactive. You must enter
your password to enter the system.
- Auto Switch: Select the time for the view of channels in sequence. The options are: 05 s,
10 s, 20 s, 30 s, 1 min, 2 min, 5 min, or never (disabled).
- Video Out Set: Adjusts the display area for each channel. Select the channel and adjust the
image vertically and horizontally. Press Ok to confi rm.
- Standard: Allows you to select between PAL or NTSC format. For Mexico and the United
States use NTSC. Video by default of the DVR system is "NTSC".
- Display: Select one of the 3 resolutions 1280 x 1024, 1024 x 768 and 800 x 600 (PAL and
NTSC) for the video output of the VGA port.
- Transparency: Adjust the level of window transparency in menus.
- Language: Select one of the 6 languages available on the system.
-Show Status: Shows or hides the recording type at the bottom of each channel.
• Record:
- Channel. Select the channel to which apply
the changes.
- Stream. Choose the recording type: only
video or audio and video (A/V).
- Bitrate. Select the bit rate value. While
larger, better image quality and more space
will occupy on your hard drive.
29 29