Steren CCTV-955 Manual De Instrucciones página 79

INSTALLATION AND USE OF A PTZ
CAMERA
PT or PTZ
settings
To operate a dome camera using
the CCTV-955 is necessary to enter
to MENU > Setup > PTZ and make
the necessary adjustments.
Take into consideration
the confi gurations of channels,
mentioned below, must be equal to
the values of the PTZ camera.
1. Select the DVR channel where you will connect the PT or PTZ camera.
2. Depending on your needs, select the same Baudrate both the camera and DVR.
3. According to your needs and according to the settings of your camera setting Data (6, 7,
or 8 bits), the index of the bit stop bit 1 or 2, check and f. control.
4. Select (Samsung, PelcoO, PelcoP, Panasonic) link protocol of your camera. Important:
this value must be the same as in the camera.
5. Select the address (Decoder) established in the PT or PTZ camera.
camera
that
37 37