English; On/Off Switch - Black and Decker XTA80EK Manual Del Usuario

ENGLISH

5. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
Additional safety instructions for sanders
Warning! Contact with or inhalation of dusts arising
N
from sanding applications may endanger the health of the
operator and possible bystanders. Wear a dust mask
specifically designed for protection against dust and
fumes and ensure that persons within or entering the
work area are also protected.
Thoroughly remove all dust after sanding.
N
Take special care when sanding paint which is possibly
N
lead based or when sanding some woods and metal
which may produce toxic dust:
- Do not let children or pregnant women enter the work
area.
- Do not eat, drink or smoke in the work area.
- Dispose of dust particles and any other debris safely.
This appliance is not intended for use by young or infirm
N
persons without supervision. Children must be supervised
to ensure they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the
N
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Electrical safety
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
Features

1. On/off switch

2. Lock-on button
3. Variable speed control knob
4. Adjustable handle
5. Tension lever
6. Retractable hood
7. Centring knob
8. Dust extraction outlet
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting a sanding belt (fig. A)
Warning! Never use the tool without a sanding belt.
4
Pull the tension lever (5) outward to release the tension
N
on the sanding belt (9).
Remove the old sanding belt.
N
Place a new sanding belt over the rollers. Ensure that the
N
arrow on the sanding belt points in the same direction as
the arrow on the tool.
Push the tension lever (5) inward to tension the sanding
N
belt.
Adjusting the sanding belt tracking (fig. B)
To ensure a correct tracking, the sanding belt must be centred
over the rollers.
Switch on the tool while holding it upside down.
N
Turn the centring knob (7) as required until the tracking of
N
the belt is centred over the rollers.
Adjusting the handle (fig. C)
The handle is adjustable to 3 positions.
Unlock the handle (4) by pulling the locking handle (10)
N
outward.
Adjust the handle in the desired position.
N
Lock the handle by pushing the locking handle inward.
N
Retracting the hood (fig. D)
The hood can be retracted for sanding in confined spaces.
Warning! The hood can only be retracted when the
adjustable handle is in the up position.
Adjust the handle (4) in the straight-up position.
N
Lift the hood (6) up.
N
To close the hood, pull the tab (11) sideways first.
N
Fitting and removing the dustbag (fig. E)
Slide the dustbag (12) over the dust extraction outlet (8).
N
To remove the dustbag, slide it off the outlet.
N
Connecting a vacuum cleaner (fig. F)
Slide the adaptor (13) over the dust extraction outlet (8).
N
Connect the hose of the vacuum cleaner to the adaptor.
N
Use
Warning! Let the tool work at its own pace. Do not overload.
Variable speed control
The variable speed control allows you to adapt the speed of
the tool to the workpiece material.
Set the control knob (3) to the desired setting. Use a high
N
speed for wood, medium speed for veneer and synthetics
and low speed for acrylic glass, non-ferrous metals and
for removing paints.