Figure 15 Led Array And Connector - Federal Signal Global Serie Instrucciones De Instalación Y Mantenimiento

Installation and Maintenance Instructions
BURN HAZARD: The LED array gets hot enough to burn you.
Always allow the array to cool before handling it.
STATIC SENSITIVE DEVICE: The circuitry of the beacon can be
damaged by an electrostatic discharge (ESD). Always follow
anti-static procedures while servicing the beacon.
Tools and replacement part needed:
• 1.5 mm A/F hexagon key
• No. 1 Phillips screwdriver
• Federal Signal LED array part no. K859500823-*.
LED ARRAY
Remove the LED Array:
1.
Disconnect power to the beacon.
2. Use the hexagon key to unscrew the set screw on the housing
one full turn.
24

Figure 15 LED array and connector

Model G-LED Global Series LED Beacon
J1 CONNECTOR