Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Step 4
Remove retaining nut from flameout probe.
Insert the flameout probe through the hole
next to the control panel, so the tip of the
probe is above the burner flame ports. Secure
with retaining nut.
Step 5
Use two M5 x 8mm bolts to secure control
panel to top ring of cooker body as illustrated.
Step 6
Use the pre-attached nuts on heat shield to
attach heat shield on the windshield with two
bolts as illustrated. Then tighten securely.
Step 7
Check spring operated temperature shutoff
sensor to make sure it moves easily up/down
when depressed with finger. Reposition wiring
if necessary to allow free movement of sensor.
17
Two Pre-attached
Nuts on Heat
Shield
Temperature Shutoff Sensor
Bolts
Heat Shield
Publicidad
Tabla de contenido
