General Characteristics - Sacopa 20894 Manual De Instalación Y Mantenimiento

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be implemented for
installation and start-up. Therefore, the installer as well as the user must read the instructions before beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the Elevated Plastic Swimming Pool Floodlamp, models 21577,
21579, 20894, 21397, 38930 and 38931 follow the instructions indicated below:
1. VERIFY THE CONTENTS OF THE PACKING:
The following accessories are included inside the box:
Elevated Swimming Pool Floodlamp: 21577 (50W) - 21579 (75W)
Elevated Swimming Pool Floodlamp Unit (Round Decorative Ring) + Floodlamp Arm Support Unit (Both
units are supplied mounted)
Transformer with cable
Elevated Swimming Pool Floodlamp: 20894 (50W) - 21397 (75W)
Elevated Swimming Pool Floodlamp Unit (Square Decorative Ring) + Floodlamp Arm Support Unit (Both
units are supplied mounted)
Transformer with cable
Self-Supporting Elevated Swimming Pool Floodlamp: 38930 (75W)
Elevated Swimming Pool Floodlamp Unit (Round Decorative Ring) + Floodlamp Arm Support Unit for Self-
suporting Pool
Transformer with cable
Self-Supporting Elevated Swimming Pool Floodlamp: 38931 (75W)
Elevated Swimming Pool Floodlamp Unit (Square Decorative Ring) + Floodlamp Arm Support Unit for Self-
suporting Pool
Transformer with cable

2. GENERAL CHARACTERISTICS

This floodlamp has been designed for use primarily in Elevated Swimming Pools. It is a Class III electric
apparatus with very low safety voltage (12 V with alternating current).
To begin operation of the Floodlamp, it must be fully submerged in the water.
The floodlamp complies with IPX8 degree of protection (resistance to penetration of dust, solid bodies and
humidity) at a nominal immersion depth of 2 m.
This floodlamp complies with international safety standards for lights, especially the EN 60598-2-18
standard: LIGHTS PART 2: SPECIFIC REQUIREMENTS SECTION 18 LIGHTS FOR SWIMMING POOLS AND
SIMILAR APPLICATIONS.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any
electric components which have been inserted or handled at locations other than its own premises.
3. INSTALLATION
The floodlamp is mounted vertically on the pool wall and secured to the edge of the wall (Fig 6).
•
This floodlamp has the advantage that it can be connected to 230V since it is equipped with a built-in
•
transformer on the cable. In order to clearly light a pool it is recommended to install a floodlamp (both
50W floodlamp and 75W floodlamp) every 10 m
In order to prevent glare, the floodlamps should be installed so that they face away from the residence or
•
usual view of the swimming pool.
Prior to installation verify that the gland seal (no. 10) has been fully tightened.
•
4. ASSEMBLY
This floodlamp has been designed for mounting primarily in an elevated swimming pool.
•
It is supplied in 2 parts: the floodlamp unit with the transformer and the appropriate cable, and the
•
floodlamp support arm unit. Verify that the support arm unit is firmly secured to the elevated swimming
pool floodlamp body (No. 1) (Fig. 1).
Insert the cable in the groove in the support arm unit (Fig. 2) until the cable has reached the outside of
•
the pool correctly.
Use screws to secure the support arm unit on the edge of the elevated swimming pool (No. 15) (Fig. 3).
Connect the cable to the electric wiring.
2 of water surface.