Pumping Instructions - Philips AVENT SCF397 Manual Del Usuario

Pumping instructions

Warning: Before you remove the pump body from your breast, always switch off the
breast pump to release the vacuum.
Warning: Do not continue pumping for more than 5 minutes at a time if you do not
succeed in expressing any milk. Try to express at another time during the day.
Warning: If the process becomes very uncomfortable or painful, stop using the pump
and consult your breastfeeding advisor.
Note: If you regularly express more than 125 ml/4 fl oz per session, you can purchase and use a
260 ml/9 fl oz Philips Avent bottle to prevent overfilling and spillage.
1. Wash your hands
thoroughly with soap
and water and make
sure that your breast is
clean.
5. Use the 'level up' and
'level down' buttons to
change the suction level
to your preference.
2. Place the breast pump
kit onto your breast.
Make sure that you
center your nipple.
90 sec.
6. After 90 seconds the
breast pump will switch
smoothly to expression
mode and slowly
increase its vacuum to
the last used expression
suction level (or level 11
when used for the first
time).
3. Press the on/off
button. The indicator
lights go on to indicate
that the device is in
stimulation mode.
7. If your milk starts
flowing earlier or if you
want to switch from
expression to
stimulation mode, you
can switch modes with
the mode selection
button.
English
4. The breast pump
starts in stimulation
mode and slowly
increases its vacuum to
the last used stimulation
suction level (or level 5
when used for the first
time).
15