Maintenance - Workzone 47625-15 Manual Del Usuario

Dual halogen worklight with stand

MAINTENANCE

Your portable worklight with tripod requires very little care and maintenance. Simply
clean the lens, lamp head, portable stand and tripod regularly with a non-abrasive
cleaner.
WARNING: Always make sure that the portable worklight is unplugged
and completely cooled down before attempting to clean it.
BULB REMOVAL AND REPLACEMENT
WARNING: Risk of severe burns. Lamp head and bulbs are extremely hot
during and immediately following use. Touching lamp head or bulb with bare
hands while unit is lit can cause severe burns. Unplug light and allow it to
cool completely before attempting to change bulb.
To remove bulb:
1. Turn OFF both lights, unplug and allow the lamp heads and bulbs to cool.
2. Remove the center screw at the top of the lamp head and lower the hinged lens
cover.
3. Using a cloth to safely grasp the burned out bulb, gently push the bulb to the right.
You will feel the bulb holder spring retract, freeing the other end of the bulb
4. Lift and remove the bulb.
To replace bulb:
To install a new bulb, follow all the instructions in the HALOGEN BULB
INSTALLATION section on page 8 of this manual.
10
service@eurocentra.net
MODEL: 47625-15 PRODUCT CODE: 47625
AFTER SALES SUPPORT
05/2015
Maintenance
1 866 558 8096