D-Link DCS-4802E Guia De Instalacion página 9

Using the DCS-37-1 Mount (optional)
Place the DCS-37-1 mounting sticker in the
desired location, then use a 6 mm drill bit to drill
the required holes 25 mm deep and insert the wall
anchors into the holes. If you plan to pass cables
through the wall, you will also need to drill a hole for
the cable channel.
Use the provided screws to mount the DCS-37-1 to
the wall.
Remove the cover from the camera.
Pass the camera connectors through the back or
bottom cable channel on the DCS-37-1. Use the
provided screws to mount the camera to the DCS-37-1
using the set of mounting holes marked B.
Adjust the angle of the camera as desired, then
put the cover back on the camera and rotate it
clockwise to lock it in place.
If you are passing the camera cables through the
wall, place the rubber stopper into the bottom cable
channel to seal it.
7
D-Link DCS-4802E Quick Installation Guide