Connecting The Camera - D-Link DCS-4802E Guia De Instalacion

You can power the DCS-4802E two different ways: Power over Ethernet
(PoE) or with a power adapter.
Powering the camera using PoE (Class 2):
Connect an Ethernet cable to the Ethernet jack on the camera. Connect the
other end of the cable to your PoE switch or PoE injector.
Powering the camera with a power adapter
(not included):
Connect a 12 V, 1.5 A power adapter to the power connector.
Connect an Ethernet cable to the Ethernet jack on the camera. Connect the
other end of the cable to your network.
D-Link DCS-4802E Quick Installation Guide

Connecting the Camera

3