Accessories
Description
Plastic sack, 60 l
Fine fi lter PTFE
Fine fi lter 4 kW
Fine fi lter 9.2 kW
Warranty
The warranty period for this machine is two years and co-
vers manufacturers faults. The warranty is valid under the
condition that the machine is used under normal conditions
on the task for which it was designed and is maintained
properly. Normal wear is not covered by this warranty.
Trouble Shooting
Problem
Motor will not start.
The motor stops directly
after starting.
Pump runs but no suction.
Pump runs but poor suction. Hole in the hose.
Machine blows dust.
Abnormal sound from
machine.
Description
Part No
46145
HEPA fi lter 4 kW
429203
HEPA fi lter 9.2 kW
429204
Other accessories — see Dustcontrol catalo-
4292
gue.
Service performed by other than Dustcontrol or it´´s aut-
horized agent voids automatically the warranty. No other
warranty expressed or implied is applicable.
Fault
Machine not connected.
Thermal overload tripped.
Incorrect fuse.
Thermal overload not set
correctly.
Hose not connected.
Hose plugged.
No plastic sack/container
on the cyclone.
Pump rotation backwards.
Plugged fi lter.
Hose too long or too small. Change the hose.
Hose is kinked.
Machine top is mounted
incorrectly.
Dust is packed in the
cyclone.
Filter is perforated or has
come loose.
Particles in the pump.
DC 5900 - 21
Part No
42869
42807
Solution
Make sure of the connection.
Wait 5 minutes.
Change to correct circuit.
Electrician should adjust.
Connect the hose.
Find and remove block.
Mount the correct sack/
container.
Electrician should change
phases.
Change or repair hose.
Clean or change fi lter.
Check and free.
Adjust the mounting.
Take off the top and clean
out.
Check the fi lters and change
if necessary.
Order service.
Part No 42838-H