Accessories; Warranty; Troubleshooting - Dustcontrol DC Storm Instrucciones Originales

Accessories

Description
Plastic sack, 60 l
Fine fi lter cellulose PTFE 44081
Fine fi lter Polyester
HEPA fi lter

Warranty

The warranty period for this machine is two years and co-
vers manufacturers faults. The warranty is valid under the
condition that the machine is used under normal conditions
on the task for which it was designed and is maintained
properly. Normal wear is not covered by this warranty.

Troubleshooting

Problem
Motor will not start.
The motor stops directly
after starting.
Pump runs but no suction.
Pump runs but poor suction. Hole in the hose.
Machine blows dust.
Abnormal sound from
machine.
2018-06-11
Part No
46145
44212
42869
Fault
Machine not connected.
Thermal overload tripped.
Incorrect fuse.
Thermal overload not set
correctly.
Hose not connected.
Hose plugged.
No plastic sack/container
on the cyclone.
Pump rotation backwards.
Plugged fi lter.
Hose too long or too small. Change the hose.
Hose is kinked.
Machine top is fi tted
incorrectly.
Dust is packed in the
cyclone.
Filter is perforated or has
come loose.
Particles in the pump.
DC Storm - 20
Description
HEPA fi lter
Other accessories — see Dustcontrol
catalogue.
Service performed by other than Dustcontrol or it´´s aut-
horized agent voids automatically the warranty. No other
warranty expressed or implied is applicable.
Solution
Check the connection.
Wait 5 minutes.
Change to correct fuse.
Electrician should adjust.
Connect the hose.
Find and remove blockage.
Fit the correct sack/
container.
Electrician should change
phases.
Change or repair hose.
Clean or change fi lter.
Check and free.
Refi t the top.
Take off the top and clean
out.
Check the fi lters and change
if necessary.
Order service.
Part No
42807
Part No 94295-B