Cleaning The Feed Dog - Texi Joy 48 Manual De Operación

CLEANING THE FEED DOG

1. Remove the needle and the presser foot.
2. Remove the needle plate set screws and remove the needle plate.
3. With a brush, clean out dust from the feed dog teeth. Insert the needle plate.
4. To prepare machine for the next use, insert the needle and the presser foot back.
NOTE: You should often clean the feed dog teeth, if the machine is intensively used.
OILING THE NEEDLE BAR
Remove the face cover.
1. Face cover screw
2. Face cover
Apply a few drops of fine quality sewing machine oil to the point indicated by the arrows in the
figures. For machine in constant use, oil two or three times a year. In case the machine does not
work smoothly due to standing idle for some time, apply a few drops of kerosene at the oiling
point, and turn the machine rapidly for a minute. Before oiling, wipe off oiling points.
Texi Joy 48
EN
81