X-LITE X-1003 Seguridad E Instrucciones página 16

Warning! In the event of an emergency, the Double Action visor lock may be disabled by
lifting the visor as normal, and pressing slightly harder than usual on the visor flap.
Maintenance and cleaning of visor and chin guard trims
X-1003 helmet visor and chin guard trims have been designed to seal the space between the
visor, the chin guard and the shell, thus preventing infiltration of air, water and dust regardless
of the conditions of use.
For good functioning of the trims, in our production lines a specific lubricant liquid (LUBRI-
TRIM) is applied on them. However, the different temperatures, the weather conditions and
the dust that accumulates during normal use of the helmet, cause the evaporation of the
lubricant liquid, resulting in drying of the trims. This can reduce the effectiveness of their fun-
ctioning and cause them to break.
To maintain the trims more effective, soft and elastic, we therefore recommend a continuous
monitoring and a frequent lubrication depending on the more or less intensive use of the hel-
met, by applying the specific lubricant liquid included in the LUBRI-TRIM kit as follows:
- remove the visor from the helmet;
- open the chin guard and clean any dirt on the trims of the shell and chin guard with
water and a soft cloth. Then dry;
- apply the lubricant liquid by following the specific instructions especially on the inner
surfaces of the lateral zones of the trim of the chin guard (Fig. 11 A) and on all external
surfaces of the lateral zones of the seal of the shell (Fig. 11 B);
- clean any excess liquid, close the chin guard and reassemble the visor.
•
(Available as an optional accessory)
1 PINLOCK ® INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjustment
external levers are turned inwards.
1.3 Place the Pinlock
Pinlock ® inner visor should be in contact with the inner surface of the visor.
1.4 Fasten one side of the Pinlock
tion (Fig. 12).
1.5 Widen the visor and fasten the other side of the Pinlock
(Fig. 13).
1.6 Release the visor.
1.7 Remove the protective film from the Pinlock
ne-sealed profile of the inner visor adheres to the visor.
1.8 Fit the visor in the helmet.
CHECKING AND ADJUSTING THE INNER VISOR STRETCHING
Check the correct system assembly by opening and closing the visor. Check that both visors
are correctly fastened and do not move.
If the inner visor is not tightly fixed to the visor, move the external adjustment levers simul-
taneously upwards to increase the stretch (Fig. 14). This operation must be carried out
gradually.
The maximum stretch is achieved when the pin adjustment external levers are turned
outwards.
® inner visor on the visor. WARNING: The silicone-sealed profile of the
® inner visor to one of the visor pins and hold it in posi-
® inner visor to the second pin
® inner visor and check that the entire silico-
16