X-LITE X-1003 Seguridad E Instrucciones página 19

1 VPS DISASSEMBLY INSTRUCTIONS
1.1 To disassemble the VPS, open the helmet visor and make sure the side slider is in
downward position (Fig. 15).
1.2 Hold the left part of the VPS and pull it outwards until the grip pawl is removed from the
VPS mechanism (Fig. 17).
1.3 Repeat the same steps on the right side of the VPS and remove it.
2 VPS ASSEMBLY INSTRUCTIONS
2.1 To assemble the VPS, open the helmet visor and make sure the side slider is in upward
position (Fig. 15).
2.2 Insert the left end of the VPS into the left side guide until the grip pawl is hooked in the
mechanism (Fig. 17).
2.3 Repeat the same steps on the right side.
2.4 Check the correct VPS operation by moving the left side slider downwards (Fig. 16) and
upwards (Fig. 15) until you hear the clicks meaning that it is in the relevant positions.
If necessary, repeat the above-mentioned steps.
- If the visor and/or VPS opening/closing mechanisms are damaged or malfunctioning,
please contact an X-lite authorized dealer.
- Do not use the helmet if the VPS has not been assembled properly.
WARNING!!!
The VPS does not replace the protection guaranteed by the visor.
• WIND PROTECTOR
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector reduces unpleasant infiltrations of air under the chin.
See Fig. 18 for the assembly and disassembly.
WARNING!!!
The Wind Protector can be easily removed. You can check the correct assembly of this
accessory by pulling it gently towards the inner part of the helmet with your thumb and
forefinger. If it moves, repeat the assembling operations.
• ROLL NECK
1 DISASSEMBLY
1.1 Undo the chin strap.
1.2 Pull out the chin strap ends from the loops in the roll neck (Fig. 19).
1.3 Release the button on the back of the left cheek pad (Fig. 22), release the roll neck
eyelet fastener (Fig. 20) and hook the cheek pad again. Repeat the same operation
for the right cheek pad.
1.4 Open the zip and remove the roll neck (Fig. 21).
1.5 After removing the roll neck, it is necessary to check that the chin strap is adjusted
correctly (see attached label).
2 ASSEMBLY
2.1 Undo the chin strap.
2.2 Insert the roll neck, fasten it and close the zip.
2.3 Insert both ends of the chin strap in the specific loops on the roll neck (Fig. 19).
2.4 Release the button on the back of the left cheek pad (Fig. 22), hook the roll neck eyelet
fastener (Fig. 20) and hook the cheek pad again. Repeat the same operation for the right
cheek pad.
19