Full Two Year Warranty; Frequently Asked Questions - Philips AVENT SCD520 Manual Del Usuario

Question
Why don't both the power-
on light of the baby unit and
the LINK light of the parent
unit come on when I press
the on/off buttons of the
units?
Why does the LINK light on
the parent unit light up red
continuously and why is the
message 'Not Linked' shown
on the display?
Why does the battery light
on the baby unit fl ash red?
Warranty

FULL TWO YEAR WARRANTY

Philips Electronics North America Corporation (USA) and Philips
Electronics Ltd (CANADA) warrant each new Philips AVENT product,
model SCD520/00, against defects in materials or workmanship for a
period of two years from the date of purchase, and agrees to repair or
replace any defective product without charge. IMPORTANT: This warranty
does not cover damage resulting from accident, misuse or abuse, lack
of reasonable care, or the affi xing of any attachment not provided with
the product. NO RESPONSIBILITY IS ASSUMED FOR ANY SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES. In order to obtain
warranty service, simply call toll-free 1-800-54-AVENT.

Frequently asked questions

This chapter lists the questions most frequently asked about the appliance.
If you cannot fi nd the answer to your question, call 1-800-54-AVENT (1-
800-542-8368) for assistance.
Answer
Perhaps the battery pack of the parent unit are empty and the parent
unit is not in the plugged-in charger. Insert the small appliance plug into
the charger, put the adapter of the charger in a wall socket and place
the parent unit in the charger. Then press the on/off button to establish
connection with the baby unit.
Perhaps the non-rechargeable batteries of the baby unit are empty and
the baby unit is not connected to an electrical outlet. Replace the non-
rechargeable batteries or connect the baby unit to an electrical outlet.
Then press the on/off button to establish connection with the parent
unit.
The baby unit and the parent unit may be out of range of each other.
Move the parent unit closer to the baby unit, but not closer than 3 feet/1
meter.
If the LINK light on the parent unit still does not start to fl ash, use the
reset function to reset the units to their default settings.
The baby unit and the parent unit are out of range of each other. Move
the parent unit closer to the baby unit.
The baby unit may be switched off. Switch on the baby unit.
The non-rechargeable batteries of the baby unit are running low. Replace
the non-rechargeable batteries or connect the baby unit to an electrical
outlet (see chapter 'Preparing for use').
ENGLISH
23