Operation; Cleaning - Super Ego 200 Instrucciones De Uso Y Mantenimiento

GB
Operating instructions
Protection against Damage
Please do not underestimate the pressure produced
by the high-pressure cleaner. If you would like to
clean sensitive surfaces it is better to use the fan jet.
(See "Adjustment of the Spray Jet" in the section"
Operation").In the case of paints or insulated facades
please begin at a considerable distance away. Move
slowly close-depending on the degree of soiling –to
the object to be cleaned. Check the progress of you
work at short intervals in order to prevent damage.
Note: Never point the high-pressure jet at other
people, animals, the device itself or electricale
equipment!

Operation

Connection
1. Use a hose to connect the water connection(9)to
the water supply.
- The water connection(9) is fixed with a filter.
- Connect the water inlet connect
with the conncetion(9).
2. Open the water supply and
check for any leaks. A low level of water loss by
the pump is normal.
3. Insert the mains plug(10)
4. Turn the main switch(8)on.
Bleeding the Device before Use
- Unscrew the high-pressure hose (4)from the high-
pressure connection(15) of the device.
- Switch on the device and allow it to run until the
water coming out of the high-pressure connection
no longer contains any bubbles.
- Switch off the machine at the main switch(8) and
screw the high-pressure hose(3)back on.
Working with the Hand Spray Gun(1)
Trigger ON: Release the lock and
pull the trigger of the gun
Caution!Recoil
Trigger OFF: Release the trigger.
During work breaks secure the hand
spray gun(1)with the lock.
Adjustment of the Spray Jet
By turning the nozzle you can vary the spray from a
narrow jet to a fan jet.
Replacing accessories
1. Turn the device off by the main switch(8).
2. Allow the pressure to escape by operating the lever
on the manual spray gun(1).
3. Change to the desired accessory and then continue
operation of the machine.
Note: When the detergent container is being used it
is not possible to obtain a
high-pressure effect.
Finishing Operation
1.Switch the device off by the main switch(8).
2.Remove the mains plug(10)from the socket.
3.Close the water supply.
4. Allow any residual pressure to escape by operating
the lever on the manual spray gun(1).
5.Secure the manual spray gun(1)with the lock.
6. Disconnect the device from the water supply by
unscrewing the hose on the water connection(9)of
the device.

Cleaning

The device must never be immersed in water to clean
it ,but should be cleaned with a soft dry cloth. In the
case of stubborn dirt slightly dampen the cloth with
water and then wipe dry
12