Operation; Cleaning; Storage; Troubleshooting - Super Ego Hidrolimpiadora 100 Instrucciones De Uso Y Mantenimiento

GB
Operating instructions
Protection against Damage
Please do not underestimate the pressure produced
by the high-pressure cleaner. If you would like to
clean sensitive surfaces it is better to use the fan jet.
(See "Adjustment of the Spray Jet" in the section"
Operation").In the case of paints or insulated facades
please begin at a considerable distance away. Move
slowly close-depending on the degree of soiling –to
the object to be cleaned. Check the progress of you
work at short intervals in order to prevent damage.
Note: Never point the high-pressure jet at other
people, animals, the device itself or electricale
equipment!

Operation

Connection
1. Use a hose to connect the water connection(3)to
the water supply.
Open the water supply and check for any leaks. A
low level of water loss by the pump is normal.
2. Insert the mains plug(9)
3. Turn the main switch(1)on
Working with the Hand Spray Gun(8)
Switching ON: Release the lock (10) and pull the lever
of the gun.
Caution!Recoil
Switching OFF: Release the lever. During work breaks
secure the hand spray gun(8) with the lock(10).
Adjustment of the Spray Jet
By turning the nozzle(5) you can vary the spray from a
narrow jet to a fan jet.
Replacing accessories
1. Turn the device off by the main switch(1).
2. Allow the pressure to escape by operating the lever
on the manual spray gun(8).
3. Change to the desired accessory and then continue
operation of the machine.
Note: When the detergent container is being used it
is not possible to obtain a high-pressure effect.
Finishing Operation
1. Switch the device off by the main switch(1).
2. Remove the mains plug(9)from the socket.
3. Close the water supply.
4. Allow any residual pressure to escape by operating
the lever on the manual spray gun(8).
5. Secure the manual spray gun(8)with the lock(10).
6. Disconnect the device from the water supply by
unscrewing the hose on the water connection(3)of
the device.

Cleaning

The device must never be immersed in water to clean
it ,but should be cleaned with a soft dry cloth. In the
case of stubborn dirt slightly dampen the cloth with
water and then wipe dry

Storage

Separate the accessories from one another. Allow the
accessories and thehigh-pressure hose to run empty.
Please note: there is still water in the pump of the
high-pressure cleaner. Frost may damage the pump or
internal piping. therefore the device should always be
stored in rooms away from frost.

Troubleshooting

Device is not working
- Check the mains connection.
- Check the position of the main switch(1).
The motor suddenly stops during operation
- Possible cause: The overheating protection of the
pump has been activated.
- Switch the machine off and allow it to cool down for
approx.20min.Then you can begin work again.
The device dose not reach the working pressure
- Bleed the machine: Allow the pump to run without
the high-pressure hose until the water coming out
of the high-pressure outlet no longer contains any
bubbles. Then reconnect the high-pressure hose.
- Clean the filter in the water connection(3).
- Check the water supply amount.
- Check the supply pipes to the pump to see if they
are leaking or blocked.
12