Reset Button - Peavey WFS 3.70Active Manual Del Usuario

ENTER DIRECT CONNECT MODE
Customer can also use point to point which called Direct mode to setup
wireless audio play direct from your wireless device such as iPhone or
wireless PC. No need to connect the WFS 3.70 to a network.
Power up the unit and double click "Setup" button, the LED flash green/
orange for about 15s, then LED is solid orange. Connect audio device to WFS
Direct by opening your wireless networks on your device and selecting WFS
Setup. Once connected directly to the speakers, choose the WFS 3.70 from
iTunes.
PLAY WIRED AUDIO
Connect to the WFS using 1/8" (3.5 mm) input from your audio device before
you power up the speaker. Press and hold Power button key for 3 seconds. It
is changed to Line In source. LED will remain flashing green.

RESET BUTTON

If you are trying to change your mode of operation and the speaker is
remaining in the last set up mode, pushing the Reset button may be required.
Once Reset is pushed, the speaker is back to its factory reset mode.
IN THE BOX
• WFS 3.70 speaker system Air Monitors
• Power supply
• Power cord
• Speaker cables
• AUX cable
• User manual