Installation Guide - AO Smith AO-WH-PREL Manual Del Usuario

INSTALLATION GUIDE

8
Place a filter (purchased separately) into clear housing. Ensure filter is centered
and seated. Screw housing with filter into head. Hand tighten until snug.
If necessary, tighten with supplied filter wrench to seal properly.
DO NOT OVER-TIGHTEN.
9
Slowly turn on main water supply while
depressing red air release button
(on filter head). Check for leaks.
Allow water to run for five (5)
minutes to flush out air.
TIMER BATTERY INSTALLATION AND CHANGE
Insert coin or screwdriver in the slot between timer cap and base. Gently pry them open
and separate timer base from cap. Install or change two (2) new AAA 1.5-volt batteries.
Line up the base and cap and snap them together. It is recommended to change the
batteries at least every two (2) filter changes. Do not mix old and new batteries.
INSTALLATION OF TIMER
Hold the timer body in the center and
gently push timer to its seat at the top
of the filter head. You may also attach
it in a remote location for easy viewing.
TIMER RESET AND APPLICATION
After new batteries are installed or filter
is changed, push and hold the blue reset
button for approximately five (5) seconds.
Release the reset button after the light
flashes five (5) times. The light will flash
again in 90 days as a reminder to change
the filter. (See Figure 5)
Do not mix alkaline, standard (carbon-zinc) or
rechargeable (ni-cad, ni-mh, etc.) batteries.
FIGURE 5
NEED HELP? GIVE US A CALL 877.333.7108
5