Installation; Tv Connection - Analog Tv; Identifying The Remote Control Buttons - Zinwell ZAT-970A Manual Del Usuario

INSTALLATION

Before connecting to other devices
When the receiver is connected to an antenna that has a signal amplifier and power supply, be
sure that the amplifier doesn't have any leakage problems before connecting the coaxial cable
to the receiver.
TV Connection – Analog TV
Connect the Antenna or Cable to the Receiver RF Input port using a coaxial RF cable.
Select AV or RF connection to your TV.
Connect the "VIDEO OUT" and "AUDIO OUT" to the "AV INPUT" jack on your TV using RCA type
cables. If you choose this AV connection, you need to set your TV to "AV", "Video" input source
etc.
Or connect the"RF OUT＂to the "RF IN＂jack on your TV by using a coaxial RF cable. Under
the RF connection, switch your TV's channel number to channel 3 or channel 4. (Refer to the TV
System operation through OSD Setup/ TV System item in page 6 of user's manual).
* ZAT-970A supports Analog Pass Through function.
Proceed to select RF through of RF Output OSD item to watch the analog channels on your TV
when the STB power is on. Then switch your TV to the suitable RF input source and select analog
channel by your TV's remote control. Refer to your TV's manual for details.
Note: It's normal to see the analog program with the video artifacts when you turn the STB off. The
signal loss will become more seriously without the power supply, so we highly recommend users
to operate Pass through function in power on mode.
Plug the supplied power cord from DC IN jack into a power outlet.

Identifying the Remote Control Buttons

Battery Installation
Use two AAA batteries (supplied)
Remove the battery cover by pushing the tab while lifting the cover up. Match the + and - ends of the
batteries with the correct marks on the remote control. Replace the battery cover.
Note: Incorrect installation can cause battery leakage and corrosion that will damage the Remote Control.
2
2