Main Components - Probuilder 32891 Manual De Instrucciones

Never adjust the mitre angle or bevel angle
while the saw is running.
Always keep the spindle and � anges used for
mounting the saw blades clean.
Never use the mitre saw if the blade guard
is not working correctly. The blade guard
should close automatically when the mitre
saw is not in use, and must NEVER be secured
in an open position.
Never allow the blade to be in contact with
the item to be cut, or other objects, when
starting the saw.
Check that the item does not contain nails,
screws or other objects that may damage the
saw blade.
The saw blade will not stop immediately
when you release the on/off button.
Tighten all lock screws and secure the
saw arm in the lowest position if you are
transporting the saw.

Main components

1. On/off button
2. Release button for blade guard
3. Carbon brush holder
4. Movable blade guard
5. Adjustable guide
6. Fixed guide
7. Pull-out rail
8. Saw bench
9. Arm with saw insert
10. Lock knob for mitre angle
11. Mitre angle release knob
12. Quick stop for � xed angles
13. Foot with mounting hole
14. Length stop on support rail
15. Lock knob for support rail
16. Lock knob for bevel angle
17. Lock knob for clamp
18. Stanchion for screw clamp
19. Telescopic extension
20. Dust bag
21. Dust extractor nozzle
22. Fixed blade guard
23. Screw clamp
24. Scale for bevel angle
25. Stop plate
26. Depth adjustment screw
27. Carrying handle
28. Spindle lock
29. Feed roller
30. Saw blade
31. Lock knob for adjustable guide
32. Lock pin for saw arm
33. Lock knob for telescopic extension
GB
41