Clearing A Material Blockage; Turning The Appliance Off; Overheating Protection - UNITED OFFICE UAVS 300 A1 Instrucciones De Uso E Indicaciones De Seguridad

Clearing a material blockage

♦ Move the REV/OFF/AUTO/FWD switch
if the material being shredded causes a jam. The appliance now goes into
reverse and the material is ejected.
♦ Alternatively, move the REV/OFF/AUTO/FWD switch
("forward") position if the material causes a blockage. The appliance is now
in forwards operation and the material that is being shredded is pulled in
again.
♦ Move the REV/OFF/AUTO/FWD switch
the jammed material has been ejected.
Turning the appliance off
NOTE
► We recommend that you switch off the appliance and let it cool down for
about 30 minutes after 3 minutes of operation to prevent overheating.
♦ Switch the appliance off by moving the REV/OFF/AUTO/FWD switch
the OFF position. The power lamp

Overheating protection

This appliance is fitted with overheating protection. If the motor overheats due to
overloading, the appliance switches itself off automatically. The overheat lamp
lights up permanently red until the motor has cooled down sufficiently.
If this occurs, do the following:
WARNING! – RISK OF INJURY!
► Pull the power plug out of the power socket to prevent unintended starting
of the appliance.
Switch the appliance off by moving the REV/OFF/AUTO/FWD switch
♦
the middle OFF position.
♦ Empty the waste collectors
♦ Allow the appliance to cool down for about 30 minutes.
♦ Replace the plug in the mains power socket.
♦ Switch the appliance on by moving the REV/OFF/AUTO/FWD switch
to the AUTO position. The overheat lamp
appliance has cooled down sufficiently.
GB │ IE
│
■ 10
8
to the REV ("reverse") position
8
to the OFF position as soon as
6
goes out.
w e
/ .
7
no longer lights up once the
8
to the FWD
8
to
7
8
to
8
UAVS 300 A1