Troubleshooting; Dvd Player; Specifications - Insignia NS-LTDVD26 Guía Del Usario

Insignia NS-LTDVD26 26" LCD TV/DVD Combo

Troubleshooting

TV
Problem Solution
No picture or sound. Check all cable connections.
Make sure that your TV combo is
turned on.
Picture is OK, but no Check the volume level and mute
sound. setting.
Sound is OK, but no color. Check the color control and adjust
it. Check the program's color
features because it may be a black
and white movie.
The picture has overlapped Make sure that the antenna is
images. installed correctly. If not, adjust the
antenna toward the broadcasting
station.
Picture has snow. Check the antenna and its
connection. If there are problems,
correct them. If all connections are
tight, the problem may be with a
faulty antenna or cable. Check car
traffic or neon signs that may
disrupt the image.
Stripes on picture. Check for interference from other
electronic devices, such as radios
and televisions, and keep magnetic
or electronic devices away from
your TV combo.
Bad stereo or SAP sound. A long distance from the
broadcasting station or interference
from radio waves can generate bad
sound reception. If so, change the
mode to Mono.
Remote control does not Remove obstacles between the
work. remote control and the player.
Point the remote control at your TV
combo's IR sensor.
Install fresh batteries.
Your TV combo displays a Check the resolution and frequency
black or blue screen. of your computer, and adjust it to
the optimum resolution for this TV:
1280 × 768 at 60Hz.
No Signal appears on the Make sure that the cable is firmly
screen. connected to the computer and TV.
Image is not clear. Adjust the phase control.
Image is not centered. Adjust the horizontal control.

DVD player

Problem Solution
No sound Make sure that your TV combo or
amplifier is working correctly.
Make sure that the amplifier is set
to receive DVD signal output.
No image Make sure that your TV combo is
working correctly.
Make sure the color system is set
correctly.
Bad sound quality Make sure that the audio output
mode is set correctly.
Make sure that the audio
connection between your TV combo
and amplifier (if used) is secure.
Problem
Disc cannot be played
The player does not operate
normally
Remote control does not
work

Specifications

LCD Panel
Resolution
Viewing angle
Contrast ratio
Brightness (cd/m
Dimension With stand
Without stand
Weight
TV TV standard
Tuning system
Frequency range
Stereo
CATV
Power Input
Consumption (Max.)
Sound Output
Terminals A/V in
Component
PC in
HDMI
Antenna in
DVD player Signal System
Applicable disc
www.insignia-products.com
Solution
Make sure that the disc is inserted
with the label facing forward.
Clean the disc.
Moisture has condensed in the
player. Remove the disc and leave
the player on for about an hour to
dry out.
Disconnect the power plug, then
reconnect it.
Remove obstacles between the
remote control and the player.
Point the remote control at your TV
combo's IR sensor.
Install fresh batteries.
26" wide TFT LCD
1366 × 768
80°/80°/70°/60°
800:1
2 500
)
26.4 × 20.4 × 8.9 inches
(670 × 517 × 225 mm)
26.4 × 18.9 × 4.2 inches
(670 × 480 × 107 mm)
30 lbs. (13.6 kg)
NTSC
Electronic tuning system
VHF/UHF
NICAM
125 channels
100-240V AC, 50/60 Hz
150 W
6 W + 6 W
Video, S-Video, Audio
L/R
Y, Pb (Cb), Pr (Cr)
D-SUB 15-pin RGB in
HDMI compliant (type A
connector)
F-type
NTSC
DVD: 12 cm
CD: 12 cm
25