② Setting Up; ③ Connecting To A Projector Or Monitor; ④ Preparation Of Supplied Accessories - Elmo PX-30 Guia De Inicio Rapido

② SETTING UP
Place the product on an even, flat surface. Then set up the product as shown in the
figures below.
When storing the product, follow the opposite procedure.
STEP1
日
本
語
③ CONNECTING TO A PROJECTOR OR MONITOR
④ PREPARATION OF SUPPLIED ACCESSORIES
●Remote control
Remove the battery case by squeezing the release lock.
Insert the coin battery into the battery case, so you see the positive (+) side
facing up.
Then insert the battery case into the remote control.
Release lock
①
②
STEP2
AC adapter
[DC IN 12V]
Rear panel
Children may ingest small batteries; always keep
batteries safe and out of reach.
③
If a battery is swallowed, consult a doctor
immediately as this could result in asphyxiation or
be an obstacle to digestion, etc.
STEP3
Lens direction
AC power cord
※PX-30 only
[RGB out]
RGB cable
WARNING
24
STEP4
To wall outlet
[HDMI out]
HDMI cable
To a projector or TV monitor