ST Quadrat LUX-top G-T Instrucciones De Montaje Y Uso página 69

®
5. LUX-top G-T toeboard/accessories installation instructions:
Where parapet heights are less than 150 mm, a toeboard is required to prevent objects from
falling off the roof!
®
NOTE: LUX-top G-T anti-slip covering is attached underneath the guardrail bases and
counterweight holder as additional slid-resistance for use of the LUX-top
toeboard!
a) Begin installing the guardrail at corners or ends
b) Align the basic elements using the toeboards or toeboard corner version.
(The toeboards dictate the post spacings)
c) Use blind rivets 4.8x10 A2 to fix the toeboards on the spreader side
(Toeboard can be moved upwards using multiholes, e.g. if gravel cover is present)
d) the length of the last toeboard or the last two toeboards (depending on the installation
situation) must be adjusted
e) Cantilevered toeboard start and end elements
must be stabilised using the LUX-top
toeboard cross-strut
f) Use the self-drilling
5.5x20 to screw the toeboard cross-strut onto
the counterweight holder and use 3 blind rivets
4.8x10 A2 each to rivet onto the start/end of
the toeboard
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection solutions – www.lux-top-absturzsicherungen.de
®
G-T
stainless steel screws
Page 29 Version 05/2019
®
G-T