Amber Light (Alarm); Green Light; Other Components - Astralpool 44738 Manual De Instalación Y Mantenimiento

FLOW SWITCH
Security switch, must be in on position before starting on the equipment. It starts working when water flows through the
heating pipe.
Factory adjusted. Do not tamper with the unit. This could lead to severe malfunctions.
MECHANICAL SEAL
Prepared for the necessary power cord for each heater.
MANUAL SWITCH
When amber light is "on" it means the heater has been turned olf due to a temperature higher than 60ºC. Heater must
then be restarted manually.
Check the possible cause of malfunction before restarting the heater. See the problems and solutions tables included.
Heater should not be restarted without checking problems. Even if it might restart properly the security system could be
affected.
To restart, unscrew the cap and press the button firmly.
Heater will only restart when temperature is bellow 35ºC, otherwise the system can not be restarted.
RED LIGHT
This light shows that the heater is on and working. It is commanded from the thermostat.

AMBER LIGHT (ALARM)

This light shows that the first security system (thermostat) has failed. The second system security switch witch the
heater off at 60ºC.
Check and solve the problem before restarting the heater.

GREEN LIGHT

It shows that the electrical power is operating the system.
Do not open or manipulate the heater when this light is on.
THERMOSTAT
Manually adjustable. Turn the dial to the desired temperature. Temperature working margin +0 -2ºC.
BUSH UNION
To be solvent welded to 1 ½" PVC pipe.

OTHER COMPONENTS:

ELECTRIC CONNECTIONS TERMINAL
Provided for the electric connections.
A R S
Anti-bounding security system. Most systems equipped with filtration can suffer flow diminution due to filter
saturation. In those cases the flow switch control could send reiterative signals to the main switch and damage it. The
ARS discards the reiterative signals to protect the main switch and increase its life.
ASSEMBLY INSTRUCTIONS
Please install it preferably below water level in vertical or horizontal position. (Fig. 1)
When installed above water level do it in such a way to avoid water discharge from the heater.
NOTE: This equipment is provided witch special clamps for wall or soil subjection.
To modify it proceed the following way:
•
Loosen the screws that hold the resistance pipe to the box.
•
Turn it to the desired position and tie the screws again.
- 5 -