Unit Conversion - Hammerhead HLLT10 Manual Del Usuario

OPERATION
5. RELATIVE ANGLE MEASUREMENT
Use the relative angle measurement to measure the angle difference between two working
surfaces.
a. Lay the digital laser level on the first working surface.
b. Turn on the digital laser level. The LCD screen indicates the absolute angle between
true level and the working surface.
c. Press the REF button to enter the relative angle measurement mode. The current
angle will be set to be 0.0°.
d. Place the digital laser level on the second working surface and the relative angle
between the first working surface and the second working surface will be displayed.
The zero line indicates the first working surface position, and the slope line indicates
the direction of the second working surface either above or below the first working
surface level.
NOTE: If the beeper is activated when working with a changed angle reference value,
the digital laser level will sound at the new reference value 0°, 45°, and 90° or the most
recently stored value.

6. UNIT CONVERSION

The UNIT button allows the desired unit of measurement to be selected: degrees (°), pitch
(IN/FT) or slope percent (%).
Pitch readings are in 1/8 in. per foot increments. Plus and minus signs indicate when the
pitch is slightly more (+) or less (-) than the level shown on the display.
The conversion button can be used while the display is in the MR mode. This feature is a
convenient way to convert angles from one unit to another. For example, a 5 in./ft. roof pitch
measurement can be converted to 22.6° for setting up cuts on a chop saw.
7. CURRENT READING MEMORY AND MEMORY RECALL
a. To save the current reading, press the M button. The digital laser level can save nine
different readings in its memory. If more than nine results are saved, the oldest ones
will be overwritten.
b. To display the measurements, press the MR button. The last nine measurements will
be displayed, beginning with the most recently saved.
c. To make a new measurement, press the M button to return to measuring mode.
10" / 24" / 48" DIGITAL LASER LEVEL 11