Operation; Battery Installation - Hammerhead HLLT10 Manual Del Usuario

OPERATION

1. BATTERY INSTALLATION

This multi-function digital laser level uses
two "AAA" alkaline batteries to power
both the LCD module display and the
laser dot.
a. Open the battery cover, located in
the middle of the back of the level.
b. Insert two new "AAA" alkaline
batteries with the polarity (+/-)
as indicated on the inside of the
battery compartment.
c. Replace the cover and close it
securely.
NOTE:
• Always turn off the tool before installing or replacing the batteries.
• Remove the batteries from the tool when not using it for extended periods.
• The 2 AAA batteries should match each other in brand and type.
• Do not mix old and new batteries.
• Remove depleted batteries immediately, and dispose of them according to the laws and
regulations governing your community.
2. TO TURN THE DIGITAL LASER LEVEL
ON AND OFF
a. Press the power button to turn
the digital laser level on. When
the screen first comes on, the
temperature is displayed in
Fahrenheit for about 2 seconds,
to indicate whether level is being
used in the optimum operating
temperature range.
b. The current angle of the digital
level is then displayed, and a slope
line of that angle is shown either
above or below the line for true level. An arrow on the display indicates whether the
digital laser level has to be moved up or down to be level. True level is reached when
the two lines are together and the angle shows 0.00°.
c. To turn off the digital laser level, press and hold the button for about 2 seconds.
8
1
2
10" / 24" / 48" DIGITAL LASER LEVEL
+