Care & Maintenance - kiwy SLF 123 Manual De Instrucciones

. In case of buckle malfunction, do not use this seat and consult your
retailer.
VII. Care & maintenance instructions
Warning: Never lubricate any component of your child seat, just
keep it nice and clean.
. Plastic parts can be easily cleaned by using just soapy water; never
use solvents, alcohol or any harsh cleaning agents.
. Cleaning: when your cover gets dirty, remove it (see below) and
wash it at 30°C; do not use chemical cleaners; do not wring, nor
nor tumble-dry; do not iron. Please observe the instructions on its
washing label.
Removing the fabric cover:
Remove the safety harness as shown in pictures 21 to 24.
Release the cover from the four buttons located at the rear of the
backrest ( Fig.26 ) .
To remove the seat cover stretches the lower elastic edge and
removes the cover by sliding it over the armrests.
The cover can be washed following the instructions on the label
inside the cover.
To place the cover back on to the child car seat, repeat these
operations, in reverse order.
COVER MAINTENANCE
In case of light soiling, sponge the fabric cover with a mild detergent
and warm water. Refer to the care label attached to the fabric cover.
MATERIALS
Frame: Polypropylene – High density Polyethylene - Polyamide - Steel
Cover: 100% Polyester
MEASUREMENTS
L: 44 cm; H: 71 cm; W: 50 cm.
11