Warning Symbol Identification - Ingersoll Rand QS1L Serie Instrucciones

- lead from lead based paints,
- crystalline silica from bricks and cement and
other masonry products, and
- arsenic and chromium from chemically treated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are spe-
cially designed to filter out microscopic particles.
• Be aware of buried, hidden or other hazards in your
work environment. Do not contact or damage cords,
conduits, pipes or hoses that may contain electrical
wires, explosive gases or harmful liquids.
• Keep hands, loose clothing, long hair and jewelry
away from working end of tool.
• Power tools can vibrate in use. Vibration, repetitive
motions or uncomfortable positions may be harmful
to your hands and arms. Stop using any tool if dis-
comfort, tingling feeling or pain occurs. Seek medical
advice before resuming use.
• Keep body stance balanced and firm. Do not over-
reach when operating this tool. Anticipate and be
alert for sudden changes in motion, reaction torques,
or forces during start up and operation.
• Tool and/or accessories may briefly continue their
motion after throttle is released.
• To avoid accidental starting - ensure tool is in "off"
position before applying air pressure, avoid throttle
when carrying, and release throttle with loss of air.
The use of other than genuine Ingersoll-Rand replacement parts may result in safety hazards, decreased tool
performance, and increased maintenance, and may invalidate all warranties.
Repairs should be made only by authorized trained personnel. Consult your nearest Ingersoll-Rand Authorized
WARNING
This is the safety alert symbol.
It is used to alert you to potential
personal injury hazards. Obey all
safety messages that follow this
symbol to avoid possible injury
or death.
2
USING THE TOOL (Continued)
Servicenter.

WARNING SYMBOL IDENTIFICATION

• Ensure work pieces are secure. Use clamps or vises to
hold work piece whenever possible.
• Do not carry or drag the tool by the hose.
• Do not use power tools when tired, or under the influ-
ence of medication, drugs, or alcohol.
• Never use a damaged or malfunctioning tool or acces-
sory.
• Do not modify the tool, safety devices, or accessories.
• Do not use this tool for purposes other than those rec-
ommended.
• Use accessories recommended by Ingersoll-Rand.
• Note the position of the reversing mechanism before
operating the tool so as to be aware of the direction of
rotation when operating the throttle.
• Use only bits, sockets and adapters which are in good
condition and are intended for use with power tools.
• Tools supported on torque reacting balance devices
shall have these devices installed to absorb the torque
reaction of the tool.
• When a suspension device is used, ensure that it is
securely fastened.
• Keep clear of pinch point between reaction bar or
support handles and any fixed object in the work
area.
• After repair or replacement of parts, tools with auto-
matic shutoff or clutch devices shall be tested to verify
that the device is functioning properly.
• Set the air pressure prior to setting the clutch to
desired torque. Maintain this pressure during use.
• The Throttle Valve Cap is under pressure from the
Throttle Valve Spring. Use care when removing the
Throttle Valve Cap.
WARNING
Always wear eye protection
when operating or performing
maintenance on this tool.
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Read this manual before
operating tool.
P7440 Edition 10