Use And Operating Mode; Tips And Recommendations; Replacing A Solar Panel - SOMFY 5119832B Guia

5. Use and operating mode

After the Oximo 40 RTS kit has been installed and commissioned, the battery is charged with electrical
energy by the solar panel:
The electrical energy transmitted by the solar panel is stored by the battery to power the Oximo 40 RTS
motor.
6. Cleaning
Make sure never to let snow accumulate on the solar panel, and that its photovoltaic cells are not
covered by snow, leaves, etc.
Keep the photovoltaic cells clean by cleaning them with clean water, using a soft cloth to avoid scrat-
ching them.

7. Tips and recommendations

7.1 Problem with the 3.2W Solar Panel ?
Problems
The roller shutter is not
operational.
The battery is recharged
several times in a year using
the external battery charger.

7.2 Replacing a solar panel

A solar panel must be replaced by a professional, and only with an identical model.
Never throw out the solar panel with domestic waste. Please take the solar panel to a collection
point or an approved centre to ensure that it is recycled.
- Deactivate the motor using the battery PROG button, see Battery Pack guide or disconnect the
battery from the motor.
- Disconnect the solar panel from the battery.
- Remove the cable from the roller shutter casing.
- Remove the rivets via the inside of the roller shutter casing.
- Remove the solar panel.
- To fit the new solar panel, perform complete reinstallation from section 3
Copyright © 2009-2016 Somfy SAS. All rights reserved.
Possible causes
The wiring is incorrect.
One of the components (motor,
battery, control point, etc.) is not
working.
The solar panel is faulty or
damaged.
The battery has reached the end
of its service life.
3.2W Solar Panel
Solutions
Check the wiring and modify it if
necessary.
See the corresponding guides.
Replace the solar panel.
Replace the battery, see Battery
Pack guide.
3