Beep Codes; Error Messages; Diagnostic Lights - Dell Precision 350 Manual De Usuario

NOTE: If the message is
not listed, see the
documentation for either
the operating system or
the program that was
running when the message
appeared.
26
Setup and Quick Re ference Guide
Configuration Displays your hardware configuration for the selected
device.
The Dell Diagnostics obtains your configuration
information for all devices from system setup, memory,
and various internal tests and displays it in the device
list in the left pane of the screen. The device list may
not display the names of all the components installed on
your computer or all devices attached to your computer.
Parameters Allows you to customize the test by changing the test
settings.
When the tests are completed, if you are running the Dell Diagnostics
4
from the Drivers and Utilities CD, remove the CD.
Close the test screen to return to the Main Menu screen. To exit the
5
Dell Diagnostics and restart the computer, close the Main Menu
screen.

Beep Codes

Your computer might emit a series of beeps that identify a problem. One
possible series (code 1-3-1) consists of one beep, a burst of three beeps, and
then one beep. This series tell you that the computer encountered a
memory problem.
If a beep code is emitted, write it down and look it up under "Beep Codes"
in the User's Guide.

Error Messages

If an error occurs during start-up, a message may be displayed on the
monitor identifying the problem. See "Error Messages" in the User's Guide
for suggestions on resolving any problems.

Diagnostic Lights

To help you troubleshoot a problem, your computer is equipped with four
lights on the back panel labeled "A," "B," "C," and "D". These lights can be
yellow or green. When the computer starts normally, the lights flash. After
the computer starts, the lights remain green. If the computer malfunctions,
the color and sequence of the lights identify the problem.