Battery Status - Jump-N-Carry JNC300XL Manual De Usuario

2. Turn off the ignition and all vehicle accessories (lights, radio, heater, etc.) before
making cable connections.
Note: A good, solid and clean connection is essential for a successful jump start
(see Performance and Temperature section).
3. Taking care to never touch the clamps together, first remove the RED POS (+)
clamp from it's ear and connect it to the RED POS (+) battery terminal. Then
remove the BLACK NEG (–) clamp from it's ear and connect it to the engine
ground, or a non-moving metal engine part. Never connect to the fuel line, fuel
injector or carburator as the engine ground.
Note: Many vehicles feature alt ernate starting points, away from the battery.
Always use the alternate starting points whenever available.
4. Make sure the cables are not in the path of moving engine parts (belts, fans, etc.).
5. Stay clear of batteries while jump starting.
6. Start the vehicle (turn on the vehicle ignition).
Note: If the vehicle doesn't start within 6 seconds, let the jump starter cool for 3
minutes before attempting to start the vehicle again or you may damage the jump
starter.
7. Once the vehicle is started, disconnect the negative (–) battery clamp from the
vehicle ground and return it to its Grip-Lock
8. Disconnect the positive (+) clamp and return it to it's Grip-Lock
9. Always return the clamps to their Grip-Lock
clamps to the handle of the jump starter.
10. After use, recharge the jump starter (see Recharging section).
The jump starter features a 12 Volt power outlet hidden behind the LED flashlight.
Remove the flashlight (taking care not to misplace or damage it) to expose the 12 Volt
outlet. To turn on the outlet, depress the yellow button. To turn off the outlet, depress the
yellow button.
Accessories up to 12 Amps can be powered by the unit. If the amperage rating is
exceeded, a built-in auto-reset circuit breaker automatically shuts power off until the
accessory, or overload source, is removed. After extreme power usage, recharge the unit
for 36-48 hours.
Press and hold the red battery level status button to display the battery status.
3 Lichter. . . . . . . . . . Gut
12 Volt DC Power
2 Lichter. . . . . . . . . . Mitte
1 Licht . . . . . . . . . . . Tiefpunkt
Aufleuchten . . . . . . . Laden Sie auf
Immer auf,
*
Bitte merken Sie dieses Licht anzeigt, dass der Auflader arbeitet.
LED Ausstellung - Presse und hŠlt roten Knopf
4 Lichter . . . . . . . . . Laden vollständig
Immer auf, wenn Auflader angeschlossen ist

Battery Status

3 lights . . . . . . . . . . Good
2 lights . . . . . . . . . . Medium
1 light . . . . . . . . . . . Low
Flashing . . . . . . . . . Recharge Unit
Always On
*
Please note this light indicates the charger is working.
ear.
®
ears after use. Never attach the
®
wenn Auflader angeschlossen ist*
When Charger is Plugged In*
ear.
®