Ubbink Pool Cleaner Manual De Usuario página 21

User Guide
I - Preparing your pool
Before using the hoover, the pool must be free of algae.
Prepare the following, if necessary:
1. Chemically stabilize the pool water.
2. Sweep the pool and wait until the dirt sets on the bottom.
3. Open the valve of the vacuum cleaning system or the skimmer.
4. Clean the pre-filter basket.
II - Assembly
Open the box and check if all the parts are available.
See figure 1.
List of parts:
1. Body of the appliance
2. Counterweight bar
3. Water flow guide device
4. Counterweights
5. Pressure regulator
6. Flapper connector
7. Anti shock ring
8. Suction pad
9. 1 0m hose (not assembled)
Step 1.
Assemble the suction pad
To assemble the suction pad, find the word «UP» on the bottom of the body of the appliance and slide
the suction pad in place with the smooth surface towards the bottom (figure 2).
Once assembled, the suction pad must be able to turn freely.
Step 2.
Put the anti shock ring on the bottom end of the body of the appliance (see figure 3).
Step 3.
Fix the counterweight bar to the top of the body of the appliance.
Make sure the top end is correctly fitted (see figure 4).
Pool depth
1,20 m or less
1,20 m - 2,15 m
2,15 m - 3,65 m
More than 3,65 m
CLEANMAGIC-DEF.indd 22
Table A
Weight Placement
1 weight: 10-30 cm (4-12") from the swivel head
2 weights: 10-30 cm (4-12") + 180 cm (6`) from the swivel head
3 weights: 10-30 cm (4-12") + 180 cm (6`) + 305 cm (10`) from
the swivel head
4 weights: 10-30 cm (4-12") + 180 cm (6`) + 305 cm (10`) + 365
cm (12`) from the swivel head
Figure 1
Figure 2
Main body Pleated seal in
groove
Sole
Pleats of
pleated seal
Figure 3
Figure 4
Locking
end clip
Main body
Flat tab
English
26/01/10 10:12