Ubbink Pool Cleaner Manual De Usuario página 22

Step 4.
Fix the counterweights to the hose parts following the length of the pool (see table A)
and assemble the hose parts (see figures 5 and 6). You must use enough section
to reach the opposite end of your pool, plus one extra section. Also use the counterweights
to ensure a balanced floating of the hose in the water. The number of weights you need
is determined by the maximum depth of your pool. The more your pool is deep the more
you will need weights. The number of weights you need for your pool is explained in table A.
One of the hose ends has 2 female hose ends with a
hose protector. This part needs to be added last and
must be connected to the skimmer or the vacuum cleaning
system of the pool.
Once your hoover is assembled, it should look like the below:
Figure 6
Female end of a male / Female Section
III - Installation
This appliance was made to be used in various types of pools. For this reason, we have added
certain parts (such as a flapper connector and an automatic pressure regulator).
You may not need these, depending on the equipment of your pool. The basic installation
is done in the skimmer or on a vacuum cleaning system.
Check if all the parts fit the configuration of your pool and follow the instructions.
Basic Installation
For pools with a skimmer, using the automatic pressure regulator. The advantage of this
installation is that the automatic pressure regulator automatically balances the water flow
between the skimmer and the appliance. We recommend the use of the automatic pressure
regulator for safety reasons and an optimal functioning. The regulator automatically adapts
itself to provide the correct pressure to the appliance for a satisfying cleaning.
1. Switch off the pump of the pool.
2. Close all filters and draft mains except for the skimmer main
where the hoover is connected.
3. Remove the basket from the skimmer.
4. Assemble the automatic pressure regulator and the flapper connector
(see figure 8)
5. Connect the pressure regulator and the flapper connector to the back
end hole of the skimmer, as shown in figure 8.
6. Put it in the pool and let it go down to the bottom. Let the hose go down
to the bottom of the pool vertically until it is completely filled with water and free of air.
7. Pass the end of the hose in the opening of the skimmer and connect the hose directly to the pressure regulator that
is already connected to the skimmer.
CLEANMAGIC-DEF.indd 23
NOTE: The hose length illustrated is not represen-
tative of actual size. You will need to use more
sections than shown
10-30 cm
180 cm
hose weights
Figure 5
Male hose end
305 cm
Female/Female section
to be added last
Figure 7
Automatic regulator
valve
2" Hose cone
Figure 8
Hose through
skimmer
opening
Automatic
regulator
valve
2" Hose cone
Female hose end
Attach hose this end
Press into bottom
of skimmer
Top of skimmer
Attach hose
this end
26/01/10 10:12