Extension Cable - Leister MINIFLOOR Instrucciones De Funcionamiento

Transport
Do not use the handle on the trans-
port box for transport with the crane.
The hot air hand tool must be cooled
down for transport.
Do not store any flammable materi-
als in the transport box.

Extension cable

• A minimum cross-section must be observed when extension cables are used.
• The extension cable must be authorized for the utilization site (e.g., outdoors) and be marked accordingly.
• When a power plant is used as an energy supply, the following applies for its nominal output:
2 × nominal output of the hot air hand tool and fitted with FI switch.
• Power plant must be grounded.
Operating readiness
Article no.
Art. 155.153 included in the scope of delivery
Art. 154.723 available as an option
Per ring from set 155.153 and 154.723
A. Push rubber band (15) onto the clamp-
ing device (16) according to the diame-
ter of the hot air hand tool (22) handle.
When using a Triac PID hot air hand tool,
a Rubber band (15) 155.153 must be
cut to size in accordance with the sketch.
15 mm
16
16
50 mm
Device is not permitted to be raised
on the additional weight/final weight
or unwinding device.
Transport damage warning:
The rapid welding nozzle (24) must
be removed prior to transport in the box
of the tubular nozzle (23).
For handle Ø in mm
57-59
64-65
60-63
15
Rubber band (15)