Parameter Settings - Leister MINIFLOOR Instrucciones De Funcionamiento

I. Align the hot air hand tool (22), rapid
welding nozzle (24),, and guide wheel
(3) with the welding groove.
If the guide wheel (3) jumps to the right
out of the welding groove during welding,
the running accuracy can be optimized
by turning the hot air hand tool (22)
clockwise. If the guide wheel (3) jumps
to the left out of the welding groove
during welding, the hot air hand tool
(22) should be turned counter-clock-
wise.

Parameter settings

Set the required welding speed on the
MINIFLOOR potentiometer (7).
Adjust the required welding temperature and
– if available – the air volume setting on the
optional hot air hand tool (22).
For the hot air hand tool (22) settings, plea-
se observe the operating instructions of the
device in use.
Level m/min
1
2
3
4
5
6
7
8
9
10
ft./min
0.4 1.3
0.9
2.9
1.3
4.3
1.7
5.6
2.3
7.5
2.7
8.9
3.1
10.1
3.5
11.5
4.0
13.1
4.3
14.1
24
22
3
7
24
22
3
22
19