Printed Circuit Boards, Position Of Fuse On Converter Printed Circuit Board - ACS contsys Flowcont M Manual De Instrucciones

7 Printed circuit boards, position of fuse on converter printed circuit board

7 Printed circuit boards, position of fuse on converter printed circuit board
D184B112U04
Connection for
excitation ca-
ble
Electrode
signal
The BR203 bridge must
be in this position for
equipment operations.
All other bridges must
be open.
They are intended for
internal purposes.
Fig. 13: Version without display
Flowcont M
20 mA module
can be plugged in
Fuse for mains Connection
500 mA T for mains
Connection for
display
TTL
connection
DIP switch for
20 mA measure-
ment range
damping etc.
Connection for
wiring harness
20 mA signal
Connection for wiring har-
ness pulse output
GB 25