Service And Maintenance - LGB 20183 Manual Del Usuario

SERVICE
Lubrication
The axle bearings and the side rod bearings should be lubricated occasionally with a
small amount of Märklin-Oil (7149).
Replacing the light bulbs (E130 023)
Front & rear lantern: Carefully pry the lens away from the lantern. Using tweezers,
remove and replace the bulb. Reassemble.
Cab light: Using tweezers, remove and replace the bulb.
Replacing the traction tire (E126 174)
• Remove the two hex head screws that attach the side rods to the rear wheels.
• Remove the side rods from the rear wheels.
• Use a small, straight-blade screwdriver to replace the traction tire: Pry the old
traction tire out of the wheel groove.
• Gently insert the new traction tire into the wheel groove.
• Make sure that the traction tire is seated properly in the wheel groove.
• Put the model back together.
Function Mapping DCC
It is possible to assign functions controlled from the decoder to function buttons
of your choice (mapping). To do this an appropriate value must be entered in the
appropriate CV.
The CVs (lines) and the functions (columns) are listed in the tables on pages 42/43.
Four CVs belong to each button. For space reasons the 4 CVs were put together in
one line starting with CV 282 (Button F5).
It is basically possible to assign several functions to one button or one function to
several buttons.
Note: The programming for function mapping should be done only by experienced
users.
Individual functions can be controlled by means of SUSI depending on the design of
the decoder. These functions can be handled by the decoder as sound. The volume
levels belonging to these functions cannot be changed.
Examples of Function Mapping:
AUX 2 is to be forwards and backwards on Function 3
CV 272 & CV 372 = 8
CV 273 & CV 373 = 0
CV 274 & CV 374 = 0
CV 275 & CV 375 = 0
Sound 15 is to be shifted from forwards and backwards on Function 3 to Function 8.
The existing function at Function 8 is overwritten in the process.
CV 275 & CV 375 = 0
CV 273 & CV 373 = 0
away from Function 3
CV 274 & CV 374 = 0
CV 275 & CV 375 = 0
CV 297 & CV 397 = 0
CV 298 & CV 398 = 0
to Function 8
CV 299 & CV 399 = 0
CV 300 & CV 400 = 4
12