Quick Operation Guide - Brandy Best RED6D Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

For detailed operating method read the corresponding content on the instruction manual.
Switch on the appliance
Fill the detergent dispenser
Check the rinse aid level
Check the regeneration
salt level
Load the baskets
Select a programme
Running the dishwasher
• Changing the programme
• Add forgotten dishes in the
dishwasher.
• If the appliance is switched
off during a wash cycle
Switch off the appliance
Turn off the water tap,
unload the baskets

2.Quick operation guide

Press the Power switch button to switch on the appliance, Open the door.
Compartment A:
With each wash cycle.
Compartment B:
For programmes with pre-wash only.
(Follow the user instructions!)
Mechanical indicator C.
Electric indicator on control panel (if provided).
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Close the door Press the programme button until the selected programme lights up.
( See the section entitled Operation instruction )
Turn on the water tap and press the Start/Pause button. The machine will start working.
• 1. A running cycle can only be modified if it has been running for a short time. Otherwise
the detergent may have already been released and the water already drained. If this is
the case, the detergent dispenser must be refilled.
2. Press the Start/Pause button ,then press the program button more than 3 seconds to
cancel the running programme.
3. Select a new programme.
4. Restart the dishwasher
• 1.Press the start/pause button to stop the machine.
2.Open the door.
3.Add the forgotten dishes.
4.Close the door, then press the start/pause button,
the dishwasher will start running again .
• If the appliance is switched off during a wash cycle, when switched on again, please re-
select the washing cycle and operate the dishwasher according to the original Power-on
state ).
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the Power button.
Since the appliance is standing by, it will power off automaticly after 30 minutes without
any operation.
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid
handling
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower basket.
5
!
WARNING!
Open the door carefully.
Hot steam may escape
when the door is
opened!

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Black6dSilver6d

Tabla de contenido