Error Codes - Brandy Best RED6D Manual De Instrucciones

Problem
The dishes are
not clean
Unsatis
-factory
washing
result
Cloudiness on
glassware
Black or gray
marks on dishes
Detergent left in
dispenser cups
The dishes are
not drying
Unsatis
-factory
drying
result

Error Codes

When some malfunctions come on, the appliance will display error codes to warn you:
Codes Meanings
E1 Longer inlet time.
E3 Not reaching required temperature.
E4 Overflow.
Failure of communication between main
Ed
PCB with TFT PCB
!
WARNING!
Possible Causes
The dishes were not loaded
correctly.
The programme was not
powerful enough.
Not enough detergent was
dispensed.
Item are blocking the path of
spray arms.
The filter combination in the
base of wash cabinet is not
clean or is not correctly fitted.
This may cause the spray arm
jets to get blocked.
Combination of soft water and
too much detergent.
Aluminum utensils have
rubbed against dishes.
Dishes block detergent cups.
Improper loading
Too little rinse-aid
Dishes are removed too soon. Do not empty your dishwasher immediately
Wrong programme selection
Using cutlery with a low-
quality coating
If overflow occurs, turn off the main water supply before calling a service.
If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
What To Do
See notes in " Loading the Dishwasher
Baskets ".
Select a more intensive programme.
See" Wash Cycle Table ".
Use more detergent, or change your
detergent.
Rearrange the items so that the spray can
rotate freely.
Clean and/or fit the filter combination
correctly.
Clean the spray arm jets. See "Cleaning the
Spray Arms".
Use less detergent if you have soft water and
select a shortest cycle to wash the glassware
and to get them clean.
Use a mild abrasive cleaner to eliminate those
marks.
Re-loading the dishes properly.
Load the dishwasher as suggested in the
directions.
Increase the amount of rinse-aid/Refill the
rinse-aid dispenser.
after washing. Open the door slightly so that
the steam can escape. Begin unloading the
dishwasher only once the dishes are barely
warm to the touch. Empty the low basket first.
This prevents water form dropping off dishes
in the upper basket.
In short programmes the washing temperature
is lower.
This also lowers cleaning performance.
Choose a programme with a long washing time.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable
for washing in the dishwasher.
Possible Causes
Faucets is not opened, or water intake is
restricted, or water pressure is too low.
Malfunction of heating elenent.
Some element of dishwasher leaks.
Open circuit or break of wiring for the
communication
23