Astralpool GEL-MF 30 Manual De Uso E Instalación página 36

INSTALLATION AND GENERAL INFORMATION
INTRODUCTION
This operation manual has been writing to give the technical
specifications as well as all the instalation instructions, start-up,
operation, maintenance and cleaning the modular equipment of ice
crusher and super ice crusher of MF electronic range.
The electronic equipment of ice crusher and super ice crusher has been
designed and manufactured with high quality level.
The equipment is tested during several hours and reassure a maximum
performance in whatever use and situation.
NOTA: It is recommended when making the installation and the maintenance
operation, follow this manual so as not to damage or reduce the quality and
security characteristics of the equipment.
- Store of ice
The equipment model MF do not have pile ice dispenser basin, thus it is
necessary to design and build one with the material most suitable according
the the decoration of the room. Having into account the following points:
The high of the basin has to be between 90 and 100 cm to make easy the
pick up of the ice.
The dimensions of the ice dispenser has to be approximately of 60 cm wide
x60 cm deep x20 cm high.
It has to have a drain to throw away the ice.
UNPACKAGING AND INSPECTION
- Ice equipment
1. Ask the assistance of the official distributor for a correct installation.
2. Check the external cartoon packaging and the wood platform used for the
delivery. Whatever obvious damage in the external packaging has to be notify
to the transport; in this case check the equipment with a representative of the
transport agency.
3. a) Cut and take out the plastic ribbons that mantain seale the cartoon
packaging.
b) Take out the cramps that fix the cartoon in the platform.
c) Open the upper side of the packaging and take out the V
protective angular plate
d) Lift the cartoon taking it out of the equipment.
4. In models MF 22, MF 30, MF 41 Y MF 51 take out frontal panel / saque el
frontal / top panel , while in model MF 61 take out top and lateral panels and
check the unit so as to verify it has not been damage during transport.
5. Take out the inner supports used for the transport as well as adhesive
ribbons.
6. Check the pipe of the cooling circuit do not graze between them and it do
not touch other pipes or surfaces; make sure the fan spin freely.
7. Check the compressor it is free of swing above their own shock absorbers..
8. Observe the details of the plate located in the back part of the frame near
the water and electrical connexions and check that the voltage of the electric
net it is suitable for the equipment.
ATTENTION: A wrong voltage of electric supply will cancel
automatically the warranty.
9. Fill in the warranty coupon located inside the User manual, refer to the
model and the serial number of the unit located in the plate fixed to the frame.
Send the coupon to your local distributor.
3