Astralpool GEL-MF 30 Manual De Uso E Instalación página 47

PROCESS OF ADJUSTMENT, REMOVAL AND
SUBSTITUTION OF THE COMPONENTS
NOTE: Reas carefully the following instructions before make a substitution or
adjustment process.
A. ADJUSTMENT THE WATER LEVEL IN THE EVAPORATOR
When the level of water is above or below than the normal level, the
regulation consists in raising and droping the level of water moving up or
down the tank
1 To raise the level of water act as following:
-
a)Take out the screw that fix the support of water tank and raise it all
the necessary until it reach the level required.
-
b ) Put the screw in the correspondent drill holes and tighten it.
14
2. To drop the level of water make the same as before but putting down the
tank.
ATTENTION. Before doing this regulation makes sure that the problem
is the level of water (check troubleshooting). Make sure the electric
supply is disconnected and the stopcock of water close so as to
prevent damages.
B. SUBSTITUTION OF THE SENSOR OF TEMPERATURE OF THE
EVAPORATOR
The correct level in the
evaporator is 25mm
1.Take out the fornatl /upper panel.
below the outlet ice
hole (discharge hole).
2. Take out the isolation of pipes that connect the evaporator with the
storage heater to accede the bulb tub weld in the pipe of the cooling pipe
A lower level of water
outlet and take out the inner sensor of temperature.
can cause a major
rubing of the ice and of
3. Look for the connection of the evaporator's sensor in the back side of the
the axis due to a
electric box and disengage it making prise with the anchored tab.
quickly freese of water.
4. To install again the sensor of the evaporator follow this process on the
other way round.
C. SUBSTITUTION OF THE SENSOR OF TEMPERATURE OF THE
CONDENSER
1. Take out the frontal / upper panel and in model MF61 take out also the
right side panel.
2. Look for the sensible bulb of the condenser sensor placed between its
wings and in the models cooled by air and take it out. In models cooled by
water take the bulb out after open the plastic bracket (it can be used again)
that fix it to the pipe of the liquid.
3. Look for the connection of the sensor of the evaporator in the back side of
the electric box and disengage it making prise with the anchored tab.
4. To install again the sensor of the evaporator follow this process on the
other way round.